Netgear WC9500 Manual de usuario descargar pdf (Pagina 68)

Signal strength at

this location

RF Planning and Deployment

ProSAFE Wireless Controller WC9500

The WiFi auto planning advisor generates a heat map that suggests the required number

of access points (15 in the figure) and the locations on the floor map to achieve the

optimum WiFi coverage that is based on the WLAN requirements that you specified (see

Step 8).

10. To see the signal strength at a location on the floor map, point to the location (-44dBm at the

location in the figure).

1. T

o switch the heat map to the 2.4 GHz or 5 GHz band, on the right, click the Band

icon.

The Band icon displays 2.4G if the heat map for the 2.4 GHz band is shown. The Band

icon displays

5G if the heat map for the 5 GHz band is shown.

12. To move an access point to another location on the floor map, drag the access point to a

location on the floor map.

Note: Moving an access point turns off the heat map.

13. To move an antenna to another location on the floor map, drag the antenna to a location on

the floor map.

Note: Moving an antenna turns off the heat map.

14. T

o regenerate the heat map, on the right, click the HeatMap

icon.

The heat map is generated and displays. Use the color information on the right as

guidance for WiFi coverage.

15. To show the map with or without grid, on the right side, click the Grid

icon.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 356 357

Sin comentarios

Netgear WC9500 Manual de usuario Pagina 68