Netgear WC9500 Manual de usuario descargar pdf (Pagina 188)

Configure Wireless and QoS Settings

188

ProSAFE Wireless Controller WC9500

7. Configure the settings in the table at the bottom of the screen as described in the following

table.

Setting Description

AP Name The name of the access point.

Access Point Channel Override these settings only if a specific need exists. From the menu, select a

channel and frequency for the access point to operate in.

Note: Changing a channel might temporarily affect the traffic on the access point.

Note: By default, the access point’s channel and frequency are set to the ones

that are enabled for the radio and profile group. If the channel and frequency are

not available on the access point, the channel and frequency are set to the ones

providing the highest performance. For more information, see Configure

Channels on page 188.

Tx Power From the menu, select the transmission power of the access point.

Note: By default, the access point’s transmission power is set to the

configuration that is selected on the basic RF Management screen. For more

information, see Configure Radio Frequency Management for an Advanced

Profile Group on page 195.

8. Click the Apply button.

The changes are saved.

Configure Channels

CAUTION:

Do not disable channel allocation unless you are debugging or an extreme

situation occurred that affects the channels.

Automatic channel allocation distributes channels across the managed access points to

reduce interference. Each wireless controller allocates channels for its managed access

points, regardless of their configured security profiles. The wireless controller detects

interference, traffic load on the access point, and neighborhood maps to determine the best

channel for an access point.

The wireless controller collects this information over the

previous 24 hours and uses this information to determine the best possible channel for the

access point.

You can configure channel allocation to allow allocation of only the specified channels when

channel allocation is scheduled to run. Channel allocation ensures that the access points use

only the channels allowed according to administration policies.

1 2 ... 183 184 185 186 187 188 189 190 191 192 193 ... 356 357

Sin comentarios

Netgear WC9500 Manual de usuario Pagina 188