Netgear WC9500 Manual de usuario descargar pdf (Pagina 37)

System Planning and Deployment Scenarios

ProSAFE Wireless Controller WC9500

The access points and wireless controller are connected in the same subnet and use the

same IP address range that is assigned for that subnet. The configuration does not include

any routers between the access points and the wireless controller. The access points are

connected to a PoE switch, which, in turn, is connected to the wireless controller. The uplink

of the PoE switch connects to a Layer 3 switch or router that provides Internet access.

 To provision the wireless controller:

Step Configuration Web Management Interface Path

1. Configure the system and network settings of the wireless

controller:

1. Configure the country code of operation.

Configuration > System > General

2. Configure the time settings.

Configuration > System > Time

3. Configure the IP address of the wireless controller.

Configuration > System > IP/VLAN

4. V

erify that VLAN 1 is set as the management VLAN and is

marked as untagged.

By default, VLAN 1 an untagged management VLAN.

5. If no network DHCP server is accessible to the access points,

configure the wireless controller’

s DHCP server

Configuration > System > DHCP

Server

2. Configure up to eight profiles, and for each profile, do at least the

following:

1. Configure an SSID for wireless access.

Configuration > Profile > Basic

2. Configure the network authentication and data encryption.

3. Assign the VLAN.

4. If necessary for the selected network authentication option,

configure the authentication server

Configuration > Security > Basic >

Authentication Server

3. Use any port of the wireless controller to connect the wireless

PoE switch.

4. Deploy the access points and connect them to the same wireless

PoE switch.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 356 357

Sin comentarios

Netgear WC9500 Manual de usuario Pagina 37