Netgear WC9500 Manual de usuario descargar pdf (Pagina 170)

Discover and Manage Access Points

170

ProSAFE Wireless Controller WC9500

The settings are described in the following table.

Setting Description

IP The IP address of the access point.

MAC The MAC address of the access point.

Model The model of the access point.

Name The name that you specified for the access point.

Building The building to which the access point is assigned. For information about selecting a

building, see Step 6.

By default, the building designation is Building-1.

For information about how to set up a custom building, see Manage a Building and

Floors for an RF Plan on page 49.

Floor The floor to which the access point is assigned. For information about selecting a

floor

, see Step 7.

By default, the floor designation is Floor-1.

For information about how to set up a custom floor

, see Manage a Building and

Floors for an RF Plan on page 49.

Status • Authentication in progress. This

status can

last several minutes.

• Applying configurations.

• Firmware upgrade.

• AP is rebooting.

• Connecting. Make sure that a DHCP server is enabled in the network;

otherwise, the managed access points remain in the Connecting state and do

not enter the Connected state.

• Connected. This

status indicates

normal operation.

• Not Connected. The wireless controller cannot communicate with the access

point at the configured IP address. The wireless controller tries to log in to

managed access points each minute. If the error is temporary

, the status

automatically changes to Connected. If the error is prolonged, verify the access

point’s IP address and network connectivity. For more information, see Resolve

Problems with Access Points on page 342.

1 2 ... 165 166 167 168 169 170 171 172 173 174 175 ... 356 357

Sin comentarios

Netgear WC9500 Manual de usuario Pagina 170