Netgear WC9500 Manual de usuario descargar pdf (Pagina 160)

Discover and Manage Access Points

160

ProSAFE Wireless Controller WC9500

7. In the Range 1 section, fill in the Start IP and End IP fields.

These IP addresses specify the range in which the wireless controller must discover

access points.

8. To add more IP address ranges for the wireless controller to search in:

a. Click the Add button.

The screen adjusts to display a second set of Start IP

and End IP fields.

b. In the Range 2 section, fill in the Start IP and End IP fields.

c. Click the Add button.

The screen adjusts to display a third set of Start IP and End IP fields.

d. In the Range 3 section, fill in the Start IP and End IP fields.

9. Click the Next button.

The Discovery Wizard Step 3 of 3 : Select Access Points to manage screen displays.

The wireless controller searches for NETGEAR products on the LAN based on MAC

address and then identifies which products are supported access point models. A

progress bar show the progress of the discovery process.

When the discovery process is finished, the total number of access points is displayed

and the table shows the access points that were discovered. For each access point, the

table includes the model number, IP address, MAC address, and site.

10. To find an individual access point, enter information in the Search field.

11. To make sure that all the access points are listed, review the discovery results.

The effectiveness of the discovery process depends in part on how the access points on

your LAN are set up. If each access point is configured with a unique IP address and is

running current firmware, discovery is simple.

1 2 ... 155 156 157 158 159 160 161 162 163 164 165 ... 356 357

Sin comentarios

Netgear WC9500 Manual de usuario Pagina 160