
Advanced Configuration
91
ProSAFE Dual Band Wireless-N Access Point with RFID Support, WNDAP380R
f. Specify the settings as explained in the following table:
Setting Description
Profile Definition
Profile Name Enter a profile name that is easy to remember. The default name is
NETGEAR-WDS-1.
Remote MAC Address Enter the MAC address of the remote wireless access point (the MAC
address of
AP2 on LAN Segment 1 in
Figure 18 on page 89).
Authentication Settings
Network Authentication
and Data Encryption
From the Network Authentication drop-down menu, select Open System,
WP
A-PSK
, or WPA2-PSK.
Your selection determines the options that the Data Encryption drop-down
menu provides, and whether the WP
A Passphrase (Network Key) field
displays.
Open System Although you can use the bridge communication without
any authentication and encryption, NETGEAR recommends
that you use WEP if you do select an open system. From
the Data Encryption drop-down menu, select one of the
following:
• None
. No authentication and encryption.
• 64-bit WEP. Standard WEP encryption, using 40/64-bit
encryption.
• 128-bit WEP. Standard WEP encryption, using
104/128-bit encryption.
• 152-bit WEP. Proprietary WEP encryption mode, using
128+24 bit encryption.
This mode functions only with
other access points that support this mode.
T
o configure WEP:
1. In the passphrase field, enter a passphrase.
2. Click Generate.
The key is generated and placed in the WEP Key field.
WPA-PSK TKIP (Temporal Key Integrity Protocol) is the standard
encryption method used with WP
A-PSK and the only
selection possible from the Data Encryption drop-down
menu.
In the WPA Passphrase (Network Key) field, enter a
passphrase. The passphrase length needs to be between
8 and 63 characters (inclusive).
Comentarios a estos manuales