Netgear WNDAP380Rv2 Manual de usuario descargar pdf (Pagina 29)

Installation and Basic Configuration

ProSAFE Dual Band Wireless-N Access Point with RFID Support, WNDAP380R

3. Select one of the following 5GHz Band radio buttons:

• 11a. 802.1

1n-compliant devices can connect to the access point because they are

backward compatible.

• 11na.

This is the default setting. If you keep the default setting, go to Step 6.

When you change the wireless mode, the Turn Radio On check box is automatically

cleared, and all fields, buttons, and drop-down menus onscreen are masked out.

4. Turn on the radio by selecting the T

urn Radio On check box.

A pop-up screen displays.

Note: Under normal conditions, you want the radio to be turned on. Turning off

the radio disables access through the wireless access point, which can be

helpful for configuration, network tuning, or troubleshooting activities.

5. Click OK to confirm the change of wireless mode.

The change does not take effect until you click the Apply button after you have completed

the wireless configuration.

6. Specify the remaining wireless settings as explained the following table:

Setting Descriptions

Wireless Network Name

(SSID)

Enter a 32-character (maximum) service set identifier (SSID); the characters are

case-sensitive. The default

is NETGEAR_11na. The SSID assigned to a wireless

device needs to match the wireless access point’s SSID for the wireless device

to communicate with the wireless access point. If the SSIDs do not match, you

do not get a wireless connection to the wireless access point.

Wireless On-Off Status This field is not configurable. It shows the status of the wireless scheduler. For

more information, see Schedule the Wireless Radios to Be Turned Off on

page 60.

Broadcast Wireless

Network Name (SSID)

Select the Ye

s radio button to enable the wireless access point to broadcast its

SSID, allowing wireless clients that have a null (blank) SSID to adopt the

wireless access point’

s SSID. Yes is the default setting. To prevent the SSID

from being broadcast, select the No radio button.

Channel / Frequency From the drop-down menu, select the channel you wish to use on your wireless

LAN.

The wireless channels and frequencies depend on the country and

wireless mode.

The default setting is Auto.

Note: It should not be necessary to change the wireless channel unless you

experience interference (indicated by lost connections or slow data transfers). If

this happens, you might want to experiment with different channels to see which

is the best. For more information, see Operating Frequency (Channel)

Guidelines on page 25.

Note: For more information about available channels and frequencies, see

Technical Specifications on page 125.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 151 152

Comentarios a estos manuales

Sin comentarios

Netgear WNDAP380Rv2 Manual de usuario Pagina 29

Comentarios a estos manuales

Relacionado con productos y manuales para Puntos de acceso wlan Netgear WNDAP380Rv2