
86 |
WG102-500, WGAP150 ProSafe™ 802.11g Wireless Access Point
3. Complete the basic SNMP fields and select the basic SNMP checkboxes as explained in
Table 4-9.
Table 4-9. SNMP Basic Settings
Field Description
Server Name Assign a unique name to the SNMP server. The default name is
NETGEAR.
SNMPv1 SNMP version 1 (SNMPv1) is supported by default. Deselect the Enable
checkbox to disable support for SNMPv1.
SNMPv2 SNMP version 2 (SNMPv2) is supported by default. Deselect the Enable
checkbox to disable support for SNMPv2.
SNMPv3 SNMP version 3 (SNMPv3) is supported by default. Deselect the Enable
checkbox to disable support for SNMPv3.
SNMP Trap SNMP traps are enabled by default. Deselect the Enable checkbox to
disable SNMP traps.
SNMP Trap Receiver Name Enter the name of the device that should receive the traps that are sent
from the wireless access point.
SNMP Trap IP Address Enter the IP address of the device that should receive the traps that are
sent from the wireless access point.
4. Click Save or Save to Flash & Activate to save your settings.
Configuring SNMP Communities
To configure SNMP communities:
Figure 4-19
Comentarios a estos manuales