Netgear GS724TS-100NAS Manual de usuario descargar pdf (Pagina 16)

16 | Chapter 1: Getting Started

GS716Tv2 and GS724Tv3 Software Administration Manual

9. Click Apply to configure the switch with the network settings.

Please ensure that your PC and the switch are in the same subnet. Make a note of these

settings for later use.

Configuring the Network Settings on the Administrative

System

If you choose not to use the Smart Control Center to configure the network information on the

switch, you can connect directly to the switch from an administrative system, such as a PC or

laptop computer. The IP address of the administrative system must be in the same subnet as

the default IP address on the switch. For most networks, this means you must change the IP

address of the administrative system to be on the same subnet as the default IP address of

the switch (192.168.0.239).

To change the IP address on an administrative system running a Microsoft

Windows

operating system, open the Internet Protocol (TCP/IP) properties screen that you access

from the Local Area Connection properties, as shown in the following figure. You need

Windows Administrator privileges to change these settings.

WARNING!

When you change the IP address of your administrative system,

you will loose your connection to the rest of the network. Be sure

to write down your current network address settings before you

change them.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 274 275

Sin comentarios

Netgear GS724TS-100NAS Manual de usuario Pagina 16