Netgear WG102 Manual de usuario descargar pdf (Pagina 75)

Reference Manual for the NETGEAR ProSafe 802.11g Wireless Access Point WG102

Advanced Configuration 5-9

202-10064-02, June 2005

How to Configure a WG102 as a Point-to-Point Bridge

Figure 5-5: Point-to-Point Bridge

Configure the WG102 (AP1) on LAN Segment 1 in Point-to-Point Bridge mode.

2. Configure the WG102 (AP2) on LAN Segment 2 in Point-to-Point Bridge mode.

AP1 must have AP2’s MAC address in its Remote MAC Address field and AP2 must have

AP1’s MAC address in its Remote MAC Address field.

3. Configure and verify the following parameters for both access points:

• Verify that the LAN network configuration of the WG102 Access Points both are

configured to operate in the same LAN network address range as the LAN devices

• Both use the same ESSID, Channel, authentication mode, if any, and security settings if

security is in use.

4. Verify connectivity across the LAN 1 and LAN 2.

A computer on either LAN segment should be able to connect to the Internet or share files and

printers of any other PCs or servers connected to LAN Segment 1 or LAN Segment 2.

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 117 118

Sin comentarios

Netgear WG102 Manual de usuario Pagina 75