Netgear WG102 Manual de usuario descargar pdf (Pagina 18)

Reference Manual for the NETGEAR ProSafe 802.11g Wireless Access Point WG102

2-4 Introduction

202-10064-02, February 2005

Autosensing Ethernet Connections with Auto Uplink

The WG102 can connect to a standard Ethernet network. The LAN interface is autosensing and

capable of full-duplex or half-duplex operation.

The wireless access point incorporates Auto Uplink

technology. The Ethernet port will

automatically sense whether the Ethernet cable plugged into the port should have a ‘normal’

connection such as to a computer or an ‘uplink’ connection such as to a switch or hub. That port

will then configure itself to the correct configuration. This feature also eliminates any concerns

about crossover cables, as Auto Uplink will accommodate either type of cable to make the right

connection.

Wireless Multimedia (WMM) Support

WMM (Wireless Multimedia) is a subset of the 802.11e standard. WMM allows wireless traffic to

have a range of priorities, depending on the kind of data. Time-dependent information, like video

or audio, will have a higher priority than normal traffic. For WMM to function correctly, Wireless

clients must also support WMM.

Compatible and Related NETGEAR Products

For a list of compatible products from other manufacturers, see the Wireless Ethernet

Compatibility Alliance Web site (WECA, see http://www.wi-fi.net).

The following NETGEAR products work with the WG102 Access Point:

• WAG511 ProSafe 108 Mbps Dual Band PC Card

• WAG311 ProSafe 108 Mbps Dual Band PCI Card

• WG311T 802.11g 108 Mbps Wireless PCI Card

• WG511T 802.11g 108 Mbps Wireless CardBus Adapter

• WG511 802.11g 54 Mbps Wireless CardBus Adapter

• WG111 801.11g 54 Mbps Wireless Bridge

System Requirements

Before installing the WG102, make sure your system meets these requirements:

• A 10/100 Mbps Local Area Network device such as a hub or switch

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 117 118

Sin comentarios

Netgear WG102 Manual de usuario Pagina 18