Netgear WNAP210 Manual de usuario descargar pdf (Pagina 56)

Advanced Configuration

ProSafe Wireless-N Access Point WNAP210

Wireless Repeater

LAN Segment 2LAN Segment 1

AP 2

All APs in repeater modeAP 1

Router

AP 3

Router

Figure 5. Wireless repeater

 To configure the access point as a wireless repeater:

1. For the first access point (AP 1) on LAN Segment 1, select Configuration > Wireless

Bridge > Bridging and Repeating. The Bridging and Repeating screen displays.

2. Select the Enable Wireless Bridging and Repeating check box. This allows you to select

a bridging mode.

3. Select Repeater, and configure enter the remote MAC address of AP 2. Click Apply.

4. Configure the second access point (AP 2) in repeater mode with MAC addresses of AP 1

and AP 3.

5. Configure the third access point (AP 3) in repeater mode with the remote MAC address of

AP 2.

6. Verify the following parameters for all access points:

• The access points are configured to operate in the same LAN network address range

as the LAN devices.

• All access points need to be on the same LAN. That is, all the LAN IP addresses of

the access points have to be in the same network.

• If you are using DHCP, all access points should be set to Obtain an IP address

automatically (DHCP Client). See Set Basic IP Options on page 13.

• All access points use the same SSID, channel, authentication mode, if any, and

encryption.

7. Verify connectivity across the LANs.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 81 82

Sin comentarios

Netgear WNAP210 Manual de usuario Pagina 56