Netgear WNAP210 Manual de usuario descargar pdf (Pagina 54)

Advanced Configuration

ProSafe Wireless-N Access Point WNAP210

5. Configure the other access point (AP 2) on LAN Segment 2 in point-to-point bridge mode.

AP 1 needs to have AP 2’s MAC address in its Remote MAC Address field, and AP 2

needs to have AP 1’s MAC address in its Remote MAC Address field.

6. Configure and verify the following parameters for both access points:

• Verify that both access points are configured to operate in the same LAN network

address range as the LAN devices.

• Both use the same ESSID, channel, authentication mode, if any, and security

settings.

7. Verify connectivity across LAN 1 and LAN 2.

A computer on either LAN segment should be able to connect to the Internet or share files

and printers of any other computers or servers connected to LAN Segment 1 or LAN

Segment 2.

8. Click Apply to save your settings.

Point-to-Multi-Point Wireless Bridge

LAN Segment 3

LAN Segment 1

Hub or switch

AP 3

AP 1

Router

APs in point-to-multi-point bridge mode

Hub or switch

AP 2

LAN Segment 2

Figure 4. Point-to-multi-point-bridge mode

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 81 82

Sin comentarios

Netgear WNAP210 Manual de usuario Pagina 54