Netgear WNAP210 Manual de usuario descargar pdf (Pagina 33)

Management

ProSafe Wireless-N Access Point WNAP210

 To set up an SNMP management interface:

1. Select Maintenance > Remote Management > SNMP. The SNMP screen displays, as

shown in the following figure:

2. Enter the following information in the SNMP fields:

• SNMP. Enable SNMP to allow the SNMP network management software, such as HP

OpenView, to manage the wireless access point through SNMPv1/v2 protocol.

• Read-Only Community Name. The community string to allow the SNMP manager to

read the wireless access point’s MIB objects. The default is Public.

• Read-Write Community Name. The community string to allow the SNMP manager

to read and write the wireless access point’s MIB objects. The default is Private.

• Trap Community Name. The community string to allow the SNMP manager to send

traps. The default is Trap.

• IP Address to Receive Traps. The IP address of the SNMP manager to receive traps

sent from the wireless access point. The default is 0.0.0.0.

3. Click Apply.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 81 82

Sin comentarios

Netgear WNAP210 Manual de usuario Pagina 33