Netgear WNAP210 Manual de usuario Pagina 99

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 126
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 98
ProSafe Wireless-N Access Point WNAP210 Reference Manual
Advanced Configuration 4-15
v1.0 March 2009
Configuring the WNAP210 as a Wireless Repeater
To configure the WNAP210 as a wireless repeater as shown in Figure 4-9:
1. Select Configuration > W
ireless Bridge > Bridging and Repeating. The Bridging and
Repeating screen displays.
2. Configure the operating mode of the
access points.
Configure WNAP210 (AP1) on LAN Segment 1 in Repeater mode with the r
emote MAC
address of AP2.
Configure WNAP210 (AP2) in Repeater mode
with MAC addresses of AP1 and AP3.
Configure the WNAP210 (AP3) in Repeater mode with
the remote MAC address of AP2.
Figure 4-9
3. Verify the following parameters for all access points:
The access points are configured to operate in
the same LAN network address range as the
LAN devices.
All access points must be on the same LAN. That is, all
the LAN IP addresses of the
access points must be in the same network.
Vista de pagina 98
1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 125 126

Comentarios a estos manuales

Sin comentarios