
Figure 4-7
ProSafe Wireless-N Access Point WNAP210 Reference Manual
4-12 Advanced Configuration
v1.0 March 2009
3. Configure the WNAP210 access point (AP2) on LAN Segment 2 in Point-to-Point Bridge
mode.
AP1 must have AP2’s MAC address in its Remote MAC Address field, and AP2 must have
AP1’
s MAC address in its Remote MAC Address field.
4. Configure
and verify the following parameters for both access points:
• Verify that both access points are configured to operate
in the same LAN network address
range as the LAN devices.
• Both use the same ESSID (Extended Service Set Identification), channel
, authentication
mode, if any, and security settings if security is in use.
Comentarios a estos manuales