Netgear WC7520 Manual de usuario descargar pdf (Pagina 62)

Access Point Discovery and Management

ProSafe 20-AP Wireless Controller WC7520

5. Click Apply to save your settings.

6. Click Back to ret

urn to the Managed AP List.

 To remove an access point from the Managed AP List:

1. On

the Managed AP List, select the check box to the right of the access point that you

want to remove.

2. Click Remove.

Note: To restore a managed access point to its original firmware and use it

once again as a standalone access point, remove the access point

from the Managed AP List. Log in to the access point’s web

management interface, upgrade the firmware to the standalone AP

firmware version, and then reboot the access point.

Plan Settings section

Site The site designation that you have selected (see Add Access Points to the

Managed List after Discovery on p

age 57).

Building After you have configured buildings (see Define and Edit Buildings and Floors on

page 42), select the building in which the access point is located from the

drop-down list.

Floor After you have configured floors (see Define and Edit Buildings and Floors on

page 42), select the floor on which the access po

int is located from the drop-down

list.

Location Enter a name that is meaningful to you.

Table 7. Access point settings (continued)

Setting Description

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 212 213

Sin comentarios

Netgear WC7520 Manual de usuario Pagina 62