Netgear WC7520 Manual de usuario descargar pdf (Pagina 57)

Access Point Discovery and Management

ProSafe 20-AP Wireless Controller WC7520

discovered at a time. You have to add the access point to the managed list, change its IP

address, and then run discovery again to discover the next access point with that IP

address.

• Make sure tha

t a DHCP server is available in the network or on the wireless controller.

Note: For troubleshooting information, see Problems with Access Points

on page 198.

Manage the Access Point List

Add Access Points to the Managed List after Discovery

After the wireless controller autodiscovers the access points, as explained in Access Point

Discovery and Discovery Guidelines on p

age 51, select the site designation and then add the

access points to the managed list so that the wireless controller can manage them.

 To select the site designation and add discovered access points to the managed list:

1. O

n the last Discovery Wizard screen (Step 3 of X: Select Access Points to manage; see

Figure 23 on p

age 56) that displays the discovered access points, select an access

point that you want to designate as a remote access point.

2. From the Sit

e drop-down list, select Remote. The default is Local. (All access points for

which you do not change the site designation to Remote are designated as Local.)

3. Repe

at step 1 and step 2 for each access point that you want to designate as a remote

access point.

4. Select

the check boxes for individual access points, or select the check box on the upper left

to select all access points.

5. Click Add.

Depending on the type of access points that have been discovered, a screen that

lets you enter or ignore a login name and password might display.

The access points are added to the Managed AP List, and the wireless controller

pgrades the firmware of the access points to the latest firmware that is loaded on the

wireless controller.

• If you want to

wait until later to add the discovered access points, you can select

Access Point > Last Discovered to view the most recently discovered access

points. From this screen, you can add the access points to the Managed AP List.

• Af

ter you have added the access points to the Managed AP List, they are removed

from the discovery results and the Last Discovered screen.

6. Select Access Point

> Managed AP List. The Managed AP List screen displays. Because

this is a wide screen, it is shown in the following two figures:

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 212 213

Comentarios a estos manuales

Sin comentarios

Netgear WC7520 Manual de usuario Pagina 57

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Netgear WC7520