Netgear WNHD3004 Guía de usuario descargar pdf (Pagina 34)

3DHD Home Theater Adapter WNHD3004 User Manual

4-10 Wireless Security

v1.0, November 2010

Connecting Additional Wireless Client Devices after WPS Setup

You can add WPS-enabled and non-WPS-enabled client devices.

Adding Additional WPS-Enabled Clients

To add an additional wireless client device that is WPS enabled, follow the procedures in “WPS

Push Button Client Setup” on page 2-3.

Adding Additional Non-WPS-Enabled Clients

If you are connecting a combination of WPS-enabled clients and clients that are not WPS enabled,

you cannot use the WPS setup procedures to add clients that are not WPS enabled. You need to

record and then manually enter your security settings.

To connect non-WPS-enabled and WPS-enabled clients to the home theater adapter, find the

default security key on the Access Point web interface, and configure the client for WPA2 using

this key.

Restricting Wireless Access by MAC Address

When a Wireless Card Access List is configured and enabled, the router checks the MAC address

of any wireless device attempting a connection and allows only connections to computers

identified on the trusted computers list.

The Wireless Card Access List displays a list of wireless computers that you allow to connect to

the router based on their MAC addresses. These wireless computers must also have the correct

SSID and wireless security settings to access the wireless router.

The MAC address is a network device’s unique 12-character physical address, containing the

hexadecimal characters 0–9, a–f, or A–F only, and separated by colons (for example,

00:09:AB:CD:EF:01). It can usually be found on the bottom of the wireless card or network

interface device. If you do not have access to the physical label, you can display the MAC address

using the network configuration utilities of the computer. In Windows XP, for example, typing the

ipconfig/all command in an MSDOS command prompt window displays the MAC address as the

physical address.

Note: The MAC Address Filter function is available only on the Access Point side. By

default, it is disabled. If enabled, it lets you filter out wireless clients for tightened

security.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 63 64

Sin comentarios

Netgear WNHD3004 Guía de usuario Pagina 34