Netgear WN1000RP Guía de usuario descargar pdf (Pagina 28)

Troubleshooting

WiFi Booster for Mobile WN1000RP

Frequently Asked Questions

NETGEAR genie keeps asking me for my wireless password, and I am sure I have

entered the correct wireless password. What can I do?

It is likely that the booster is placed at the borderline o

f the range covered by the router. To

resolve this, follow the instructions in Position the Booster on p

age 8. If you are using WEP

security, make sure that you are typing the wireless key in the correct field.

I connected to NETGEAR_EXT and launched a browser. Why am I unable to see

NET

GEAR genie?

First, make sure that your computer is set

up to use DHCP (most are). Second, make sure

that the PC to Booster LED is solid green and you have a valid IP address. Finally, relaunch

the browser, and enter www.mywifiext.net.

Does the booster work if I connect it to the router with an Ethernet cable?

No. The booster is designed to connect wirelessly to the

router.

I have enabled a wireless MAC filter, also called wireless access control (ACL) on my

router

. What should I do when installing the booster?

The wireless device MAC address is translated to another MAC address when the wireless

device

connects to the booster. If your router MAC filter is enabled, the wireless device will

not be able to get the IP address from the booster. To allow this wireless device to access the

Internet, you must add the translated MAC address into the router.

 To get the translated MAC address:

1. Disa

ble the MAC filter on your router.

2. Power

on the booster and connect all of your wireless devices to the booster.

3. Make sure tha

t the Link Rate LED remains lit.

4. Log

in to your router and check the attached devices on the Attached Devices screen. Add

any MAC addresses that begin with 02:0F:B5 into your router’s MAC filter table.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34 35

Sin comentarios

Netgear WN1000RP Guía de usuario Pagina 28