Netgear WMS5316 Manual de usuario descargar pdf (Pagina 13)

Chapter 2: Access Point Discovery | 13

2. Access Point Discovery

You can discover supported NETGEAR access points on the LAN that can be managed by the

wireless management system. See Appendix A, Access Point Firmware Compatibility for a list of

compatible access points. The wireless management system supports Auto Discovery and IP

Discovery.

• Auto Discovery: Use this feature if the wireless management system and all access

points on the LAN are in the same IP subnet. This is a Layer 2 discovery method.

• IP Discovery: If the wireless management system and access points use different IP

subnets, you can use IP discovery to find the access points for each subnet (one subnet

at a time). This is a Layer 3 discovery method.

Note: For discovery to work, each access point must have an IP address.

If more than one access point has the same default IP address, then

only one of them is discovered with the model number at a time. You

have to add the access point to the managed list, change its IP

address, and then run discovery again to discover the next access

point with the default IP.

Auto Discovery

Use Auto Discovery if the wireless management system and all access points on the LAN

are in the same IP subnet. The process of Auto Discovery depends on how your access

points are configured.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 65 66

Sin comentarios

Netgear WMS5316 Manual de usuario Pagina 13