Netgear WC7600 Manual de usuario descargar pdf (Pagina 46)

RF Planning

ProSAFE Wireless Controller WC7600

Figure 14.

The Planning Buildings screen shows a tab for each building that you previously defined.

For each building, the screen shows the floors that you previously defined.

2. Select the building and floor that you want to configure by clicking the corresponding tabs.

3. Specify the WLAN requirements for the floor as explained in the following table:

Table 6. Floor WLAN requirements

Setting Description

Access Point Model Specify the access point model that you will use on the floor by selecting the

WNDAP 350, WNAP 210, WNAP 320, or WNDAP 360 radio button.CHANGE

SCREEN,

Frequency Band Select one of the following radio buttons to specify the frequency band that the access

points will function in:

• 802.1

1b//jointfilesconvert/28571/bg/ng

• 802.1

1a/na

Signal Quality Specify the required signal quality by moving the slider or by entering a percentage in

the field to the right of the slider

. The minimum signal quality is 25 percent; the

maximum is 100 percent.

Client Per Radio Specify the expected maximum number of clients per access point by moving the

slider or by entering a number in the field to the right of the slider

. The maximum

number of clients that you can configure per access point is 64.

Total Clients Specify the expected total number of clients on the floor by moving the slider or by

entering a number in the field to the right of the slider

. The maximum number of total

clients that you can configure on the floor is 1024.

4. Click Estimate to view the number of access points required for the settings that you

entered. The number of access points displays in a pop-up window. Access points that you

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 306 307

Sin comentarios

Netgear WC7600 Manual de usuario Pagina 46