Netgear WMS105-10000S Manual de usuario descargar pdf (Pagina 10)

10 | Chapter 2: Access Point Discovery

ProSafe 5 AP Wireless Management Software WMS105

To use Auto Discovery:

1. On the Configuration tab select Access Point Discovery.

2. Click Search.

• The Wireless Management Software searches for NETGEAR products on the LAN

based on MAC address, and identifies which are access points.

• The access points located through discovery are displayed on the screen.

3. Check the discovery results to make sure that all the access points are listed. See

“Discovery Results” on page 11.

4. Add the access points as described in “Adding Access Points” on page 12.

IP Discovery

Use IP discovery to discover access points in a different IP network than the Wireless

Management Software. You can search for a maximum of 255 IP addresses at a time.

NETGEAR recommends that you split up your search if you have access points in multiple

networks.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

Sin comentarios

Netgear WMS105-10000S Manual de usuario Pagina 10