Netgear WG302v1 Manual de usuario Pagina 79

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 98
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 78
NETGEAR ProSafe 802.11g Wireless Access Point WG302 Reference Manual
Advanced Configuration 4-7
v4.0, April 2006
Both use the same ESSID, Channel, authentication mode, if any, and security settings if
security is in use.
5. Verify connectivity across the LAN 1 and LAN 2.
A computer on either LAN segment should be able to connect to the Internet or share files and
printers of any other PCs or servers connected to LAN Segment 1 or LAN Segment 2.
6. Click Apply.
Configuring a Multi-Point Bridge
To configure multi-point wireless bridging as shown in Figure 4-6:
1. Under Advanced on the maim menu, select Advanced Access Point Settings. The Advanced
Access Point Settings screen will display.
2. Configure the Operating Mode of the ProSafe 802.11gs.
WG302 (AP1) on LAN Segment 1 in Point-to-Point Bridge mode with the Remote MAC
Address of AP2.
Because it is in the central location, configure WG302 (AP2) on LAN Segment 2 in Point-
to-Multi-Point Bridge mode. The MAC addresses of the adjacent APs are required in AP2.
Configure the WG302 (AP3) on LAN 3 in Point-to-Point Bridge mode with the Remote
MAC Address of AP2.
Figure 4-5.
LAN
Segment 1
Router
AP in
Point-to-Point
Bridge Mode
AP in
Point-to-Point
Bridge Mode
LAN
Segment 2
Hub or Switch
AP1
ETHERNET
RESET
5-12V DC
AP2
ETHERNET
RESET
5-12V DC
Vista de pagina 78
1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 97 98

Comentarios a estos manuales

Sin comentarios