Netgear PROSAFE WG302v2 Manual de usuario Pagina 94

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 102
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 93
NETGEAR ProSafe 802.11g Wireless Access Point WG302v2 Reference Manual
C-12 Command Line Reference
v1.0, May 2006
RADIUS Server Settings
The commands in Table C-10 correspond to the RADIUS Server Settings page on the Web UI.
Set Network Authentication to
WPA and WPA2 with RADIUS
set interface wlan0 security wpa-enterprise
set bss wlan0bssvap0 wpa-allowed on
set bss wlan0bssvap0 wpa2-allowed on
Enable Wireless Client Security
Separation
set radio wlan0 station-isolation on
Disable Wireless Client Security
Separation
set radio wlan0 station-isolation off
Set the VLAN ID for the Security
Profile
set vap vap0 with radio wlan0 vlan-id <1-4096>
Table C-10 RADIUS Server Settings
Task Command
Set the IP Address of the
Primary Authentication Server
set radius-client
primary-authentication-server <ip_address>
Set the Port Number of the
Primary Authentication Server
set radius-client
primary-authentication-port <port_number>
Set the Shared Secret for the
Primary Authentication Server
set radius-client
primary-authentication-key <value>
Set the IP Address of the
Secondary Authentication
Server
set radius-client
secondary-authentication-server <ip_address>
Set the Port Number of the
Secondary Authentication
Server
set radius-client
secondary-authentication-port <port_number>
Set the Shared Secret for the
Secondary Authentication
Server
set radius-client
secondary-authentication-key <value>
Set the IP Address of the Pri-
mary Accounting Server
set radius-client
primary-accounting-server <ip_address>
Table C-9 Security Profile Settings (continued)
Task Command
Vista de pagina 93
1 2 ... 89 90 91 92 93 94 95 96 97 98 99 100 101 102

Comentarios a estos manuales

Sin comentarios