Netgear WPN802 Manual de usuario descargar pdf (Pagina 21)

Reference Manual for the NETGEAR RangeMax™ Wireless Access Point WPN802

Basic Installation and Configuration 3-3

202-10101-01, 4 May 2005

2. Configure the computer with a static IP address of 192.168.0.210 and 255.255.255.0 as the

Subnet Mask.

3. Connect an Ethernet cable from the WPN802 to the computer.

Figure 3-1: WPN802 connected to a computer during configuration

4. Turn on your computer, and connect the power adapter to the WPN802. Then check the lights

on the front:

• Power: The power light should be lit. If the power light is not lit, check the

connections and check to see if the power outlet is controlled by a wall switch that is

turned off.

• Test: The test light blinks when the WPN802 is first turned on.

• WLAN: The wireless light should be lit.

• Ethernet: The Ethernet (LAN) light should be lit (amber for a 10 Mbps connection

and green for a 100 Mbps connection). If not, make sure the Ethernet cable is securely

attached at both ends.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 87 88

Sin comentarios

Netgear WPN802 Manual de usuario Pagina 21