Netgear WNAP320 Guía de usuario descargar pdf (Pagina 20)

20 | Chapter 2. Installation and Basic Configuration

ProSafe Wireless-N Access Point WNAP320 Reference Manual

2. Specify the fields as explained in the following table:

3. Click Apply

to save your settings.

To configure time settings:

1. Select Confi

guration > System > Basic > Time. The Time screen displays:

Figure 9.

2. Specify the fields as explained in the following table:

Table 2. Basic General System Settings

Field Description

Access Point Name This unique name is the wireless access poi

nt NetBIOS name. The name is printed

on the rear label of the wireless access point. The default is netgearxxxxxx, where

xxxxxxx represents the last 6 digits of the wireless access point MAC address. You

can replace the default name with a unique name up to 15 characters long. The

access point name can be retrieved through SNMP.

Country/Region From the Country/Region drop-down list, se

lect the country where the wireless

access point is installed.

Note: It might not be legal to operate this wireless access point in a region other than

one

of those identified in this field.

Table 3. Time System Settings

Field Description

Time Zone Select the time zone to

match your location.

Current Time This is a nonconfigurable field that

displays the current date and time.

NTP Client Enable the Network Time Protocol (NTP) cli

ent to synchronize the time of the

wireless access point with an NTP server. By default the Enable radio button is

selected.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 125 126

Sin comentarios

Netgear WNAP320 Guía de usuario Pagina 20