Netgear WG511T Guía de usuario descargar pdf (Pagina 29)

NETGEAR 108 Mbps Wireless PC Card WG511T User Manual

Network Connections and Wireless Security 2-9

v3.0, January 2007

c. Click Close to exit the Smart Wizard, or Cancel to return to the previous settings.

3. Configure the PC network settings.

a. Configure each PC with either a static IP address or with the IPX protocol.

b. Restart the PCs.

4. Verify wireless connectivity between your peer devices.

Verify connectivity by using the Ping program:

a. On the Windows taskbar click the Start button, and then click Run.

b. Assuming the target PC is configured with 192.168.0.1 as its IP address, type

ping -t

192.168.0.1

and then click OK.

c. This will cause a continuous ping to be sent to the device with the 192.168.0.1 static IP

address. The ping response should change to “reply.”

At this point the connection is established.

Note: For instructions on configuring static IP addresses, refer to the networking

tutorial on your NETGEAR CD.

Figure 2-7

Figure 2-8

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 47 48

Sin comentarios

Netgear WG511T Guía de usuario Pagina 29