Netgear WN3000RPv3 Guía de instalación Pagina 1

InstallationN300 WiFi Range ExtenderModel WN3000RPv3

105. When prompted, type the network password (also called passphrase or security key) in the Password field and click the Continue button.6. In the

118. If the screen is still displayed on your computer or device, select the following check box and click the Continue button.A message displays con

12Find the Best LocationIf the WiFi signal is weak, the first time you join the extender network, an arrow LED blinks for two minutes. If this happens,

13Connect an Ethernet-Enabled DeviceAer the extender is connected to your existing WiFi network, you can connect a wired device to the extender using

142. Connect the extender to an existing WiFi network.3. Plug the Ethernet cable from an Ethernet-enabled device in to the Ethernet port on the exte

15The NETGEAR genie screen displays.5. Select the Access Point (Wired) radio button.6. Use an Ethernet cable to connect the extender to a router Eth

16Log In to Access Extender SettingsAer installation, you can log in to the extender to view or change the extender’s settings. 1. Connect a compute

17I am connected to NETGEAR_EXT and launched a browser. Why can’t I see the web browser setup guide?Try these troubleshooting steps:• Make sure that

18I enabled a wireless MAC filter, wireless access control, or access control list (ACL) on my router. What should I do when installing the extender?Wh

19A login screen displays.b. Enter admin for the user name and password for the password. 5. Select Maintenance > Network Devices.The Network Dev

2Getting StartedThe NETGEAR WiFi Range Extender increases the distance of a WiFi network by boosting the existing WiFi signal and enhancing the overal

July 2014Netgear, Inc.350 East Plumeria DriveSan Jose, CA 95134, USATechnical SupportThank you for purchasing this NETGEAR product. Aer installing yo

3Meet Your ExtenderBefore you install your extender, familiarize yourself with its LEDs, buttons, and port.Front PanelRouter Arrow LEDClient Arrow LED

4Side and Bottom PanelsFactory Reset buttonEthernet portWPS buttonPower On/O button

5LED DescriptionsRouter Link LED This LED indicates the connection between the extender and the router or access point.Solid green. Best connection.So

6Install the WiFi ExtenderPlace the extender, apply power, and connect it to your WiFi network.Place the Extender and Apply Power1. Place your extend

7Connect with WPSWi-Fi Protected Setup (WPS) lets you join a secure WiFi network without typing the network name and password. Note: WPS does not sup

84. Connect your WiFi devices to the new extender network.Use the same WiFi password that you use for your WiFi router.5. Unplug the extender and mo

9The NETGEAR genie screen displays.3. Select the WiFi Range Extender (Wireless) radio button and click the Continue button.The extender finds WiFi net