Bridging and repeating with WNDAP330 This document describes the different options to setup Bridging and Repeating (WDS – Wireless Distribution
Access Point 1 • Enter the MAC Adress of Access Point 2 ( ) in the Remote MAC Address field. • Enter your Network Authentication details. Ma
Final Notes - Bridging and Repeating will not reach 802.11n speeds even if one of the 11gn or 11an speeds are selected - Bridging and Repeating
Introduction – WDS A Wireless Distribution System (WDS) is a system that allows access points to be wirelessly connected. WDS offers two modes of o
Wireless Repeating This option is designed to allow extending the Wireless reach of an existing AP adding a maximum of two hops, in order to conne
Access Point 1 • In each Access Point, in the Wireless Bridge Page, enable Wireless Bridinging and Repeating and select the option for Repeater.
Access Point 1 • Enter the MAC Adress of Access Point 2 ( ) in the Remote MAC Address field. • Enter your Network Authentication details. Make
Wireless Point-to-Point Bridge This option is designed to bridge wirelessly two locations in the same network. By default when enabling this opti
Wireless Point-to-Point Configuration Access Point 1 Access Point 2 • In each Access Point, in the Wireless Bridge Page, enable Wireless Br
Wireless Point to Multi-Point Bridge This option is designed to allow connection of one central AP (Master) to other Bridge-Mode stations. Each o
Wireless Point to Multi-Point Configuration Access Point 1 Access Point 2 • On Access Point 1, in the Wireless Bridge Page, enable Wir
Comentarios a estos manuales