Netgear WN802T Manual de usuario descargar pdf (Pagina 60)

RangeMax NEXT Wireless-N Access Point WN802T Reference Manual

5-4 Advanced Wireless Bridging

v1.0, August 2007

• If using DHCP, all wireless access points should be set to “Obtain an IP address

automatically (DHCP Client)” in the IP Address Source portion of the Basic IP Settings

menu.

• That all wireless access points are using the same SSID, Channel, WEP authentication

mode, if any, and encryption (WPA is not available in bridge modes).

• That each Point-to-Point AP has the Multi-Point AP MAC address in its Remote AP MAC

address table.

• If Access Control has been enabled on the APs, verify that the Wireless Cards table (MAC

Address List) for each AP is complete and accurate.

3. Verify connectivity across the LANs.

• If you checked the Enable Wireless Client Association radio box on each AP, wireless

clients will be able to use the AP.

• A computer on any LAN segment should then be able to connect to the Internet or share

files and printers with any other PCs or servers connected to any of the three LAN

segments.

• If Access Control Lists are enabled on the APs, only computers in the access control list

will be able to use the AP.

Configuring Repeater with Wireless Client Association

In this mode, the WN802T will operate as a Repeater only, and send all traffic to the remote

wireless access point. You must enter the MAC address (physical address) of the remote wireless

access point.

Note: You can extend multi-point bridging by adding a total of six WN802T APs

configured in Point-to-Point mode to connect additional wireless LAN

segments.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 77 78

Sin comentarios

Netgear WN802T Manual de usuario Pagina 60